Brake rotor and caliper on a car on a lift, wheel removed

Brake repair in Denver

Pads, rotors, calipers and fluid, measured and photographed before we quote, most jobs back the same day.

Signs it needs a look

What drivers describe when they call, what it usually means, and how soon to come in.

  • Stop when safe
  • Book this week
  • Next visit
  • Red brake light stays on

    Low brake fluid or a hydraulic fault. Check that the parking brake is fully off, then call before driving further.

    Stop when safe
  • Squeal or grinding when you brake

    A squeal is often the pad wear indicator. Grinding means metal on metal and a rotor at risk.

    Book this week
  • Pedal feels soft or sinks

    Air or a leak in the hydraulic system, and longer stops. Drive only to the shop, or call for a tow.

    Stop when safe
  • Hot, sharp smell after a drive

    A sticking caliper or parking brake dragging a pad. That wheel is often hotter than the others.

    Book this week
Clear tube from a caliper bleeder screw into a bottle of brake fluid

What we check and do

  • MeasurePad and rotor thickness against the minimum, fluid moisture, hoses. Photos go with the estimate.
  • ReplacePads and the rotors that are out of spec. Calipers only when they leak or stick.
  • Bleed and torqueAir bled from the lines, wheel bolts torqued to the maker's figure.
  • Road testPads bedded in on a test drive before you get the keys back.

What it costs

Parts and labor for a typical car. The written estimate for yours comes by text before any work, at the posted rate of $165 an hour.

  • How longPads on one axle take one to two hours. Pads and rotors on both axles take about three hours.
  • Warranty24 months or 24,000 miles on parts and labor. Demo value for this fictional shop.
Brake repair prices
JobPrice
Brake inspectionCredited to the repair if you approve it within 30 days$69
Pads, per axlePads, new hardware, caliper slides cleaned and greased, road test$229
Pads and rotors, per axleWhen the rotors measure under the minimum thickness$429
Brake fluid exchangeFull flush with the fluid type your car calls for$129
Caliper, per sideNew or remanufactured caliper, system bledfrom $289

Questions drivers ask

Do I need new rotors with every brake job?

No. We measure each rotor and replace it only when it is under the minimum thickness stamped on it, warped or cracked. The measurement is on your estimate.

Why do brakes wear faster after mountain trips?

Long descents on I-70 keep the pads hot for miles. Using a lower gear on the way down saves pads and rotors. We note the measured thickness at every visit so you can see the trend.

Can I drive with the brake light on?

Not far. Check the parking brake first. If the light stays on, call us: we tell you whether to drive in or arrange a tow.

Book an inspection

Call during opening hours or send the form. We answer the same business day with a drop-off time.

  • You call or writeTell us the car, the mileage and what you notice.
  • We give you a timeA drop-off slot, or the key drop slot for an early start.
  • You approve the estimateNothing is repaired before you say yes to the written price.